PROTEUS : Electronic Design Automation Software Review/Technical Review [ Final PART 4]

IOT BUILDER:  IoT (Internet of Things) Builder is a world's first product, providing an end to end workflow for the design of IoT appliances on Arduino or Raspberry Pi hardware. It can be added to either the Visual Designer for Arduino or the Visual Designer for Raspberry Pi product to allow the development of remote user interfaces to embedded design products.
The workflow is flexible and intuitive. Start by designing the product hardware on the schematic by adding electronic shields, sensors and breakout boards via the peripheral gallery. Then use the controls gallery to create the front panel, adding and placing dials, buttons, charts, etc. in the IoT Builder editor. Finally, use Visual Designer flowchart methods or C code (Arduino) / Python code (Raspberry Pi) to bind the user interface to the electronics.

At any time during development the entire system can be tested and debugged in the Proteus VSM simulation. This executes the program through the CPU model and any connected peripherals as well as simulating the interaction of the front panel with the electronics.
Once everything is working as expected, the firmware and front panel can be deployed to the real hardware at the press of a button. The final step is to point the target device at the hardware, watch it acquire the front panel over TCP/IP and then control the remote hardware from your mobile phone, tablet or PC.